Updated May 2026 · Local pricing for the Salt Lake City metro area
Free quotes from pre-screened local contractors. No signup required.
Powered by Thumbtack
Prices estimated using the NailThePrice Local Cost Model™ — national averages adjusted for West Jordan's labor rates, cost of living, and material pricing.
The cost to install radiant floor heating in West Jordan ranges from $2,510 to $12,030, with most homeowners paying around $5,510. Your actual cost depends on several factors specific to your home and the Salt Lake City market.
Electric mat systems cost $8–$15 per sq ft and are ideal for single rooms. Hydronic (hot water) systems cost $10–$20 per sq ft but are more efficient for whole-home heating.
Radiant floor heating is priced per square foot — larger areas cost proportionally more but have lower per-square-foot rates due to economies of scale.
Tile and stone transmit heat best. Hardwood works well with low-temperature systems. Carpet insulates against heat transfer and reduces effectiveness.
Installing during new construction or a remodel (before flooring goes down) is 30–50% cheaper than retrofitting under existing floors.
Programmable thermostats with floor sensors ($50–$200) optimize comfort and energy use by maintaining precise floor temperatures.
Mountain region costs are rising with population growth. High altitude and variable weather can affect project timelines. Skilled trade labor is in high demand in booming markets.
The expensive mistake with radiant floor heat usually happens before the floor is even finished. I've seen heating mats get nicked by a trowel, screwed through during underlayment, or damaged by another trade walking across the floor without realizing what was underneath. Everything tests fine at rough-in, tile goes down, and then suddenly half the floor never heats evenly again. At that point, nobody wants to hear the words "start removing tile."
A lot of homeowners also assume radiant floor heat behaves like forced air heat. It doesn't. Electric radiant works best as a comfort upgrade. Warm tile in a bathroom at 6 AM feels great. Trying to use electric radiant as the primary heat source for large living spaces is where people sometimes get disappointed, especially after seeing the electrical load required to do it properly.
The amperage climbs fast once the heated area gets bigger. Small bathrooms are usually straightforward. Larger kitchens, basements, or open living spaces can mean multiple dedicated circuits, larger thermostats, load calculations, and sometimes panel capacity concerns that nobody accounted for during the flooring estimate. I've seen flooring projects fully planned before anyone stopped to ask where the new circuits were actually coming from.
One thing I pay attention to immediately is whether the installer seems to have a real plan for floor sensors and zoning. Bad sensor placement causes all kinds of strange performance issues later. So does trying to control too much floor area from one thermostat just to save money upfront.
I should be clear that I'm talking specifically about electric radiant systems here, not hydronic radiant tied into a boiler. Hydronic systems are a different conversation and much more mechanical/plumbing driven. On the electrical side: dedicated circuits, GFCI protection, thermostat loads, and whether the system was coordinated before the floor got closed up permanently.
The people happiest with radiant floors are usually the ones who use it surgically. One bathroom. Maybe a kitchen. A mudroom you walk through every cold morning. That tends to feel a lot better long term than trying to turn the entire house into a giant heated slab.
Budget $76–$306 for permits and inspections. Your contractor typically handles the permit process, but confirm this upfront.
Hiring a pro? Make sure they're properly licensed — see verify HVAC technician licensing in Utah.
Heating efficiency matters more in cold climates. High-efficiency units (95%+ AFUE for furnaces) cost more upfront but save significantly on heating bills over time. Heat pump systems may need supplemental heating below 0°F.
While possible for experienced homeowners, radiant floor heating installation involves significant complexity. In West Jordan, you may still need a licensed pro for permits and inspections. DIY could save $2,317–$2,979 in labor.
Compare licensed, insured contractors serving Salt Lake City.
Powered by Thumbtack
The average cost to install radiant floor heating in West Jordan ranges from $2,510 to $12,030, with most homeowners paying around $5,510. This estimate includes both labor ($3,310) and materials ($2,200). Costs in West Jordan are near the national average due to local cost of living and labor market conditions. Get multiple quotes from licensed West Jordan contractors to lock in the best price.
Yes, West Jordan typically requires a permit for radiant floor heating installation. Budget $76–$306 for permit fees and expect 1–2 weeks for approval. Your contractor typically handles the permit application. Working without a required permit can void warranties and create problems when selling your home.
Most radiant floor heating installation projects in West Jordan take 3–7 days to complete. The timeline depends on project scope, contractor availability in the Salt Lake City metro area, and seasonal demand. Scheduling during West Jordan's off-peak season (typically fall and winter) can reduce wait times and may lower costs.
Electric radiant floor heating costs roughly $0.30–$0.50 per day per bathroom-sized room. Hydronic systems are cheaper to operate, especially with an efficient boiler. Overall operating costs are comparable to or lower than forced-air heating because radiant heat feels warmer at lower thermostat settings.
Yes, but it's more complex and costly than new-construction installation. Electric mats can be installed under tile during a floor replacement. For existing floors you don't want to remove, some systems install in the joist bays below the floor from the basement or crawlspace.